參數資料
型號: DS33ZH11+
廠商: Maxim Integrated Products
文件頁數: 83/172頁
文件大?。?/td> 0K
描述: IC MAPPER ETHERNET 100CSBGA
產品培訓模塊: Lead (SnPb) Finish for COTS
Obsolescence Mitigation Program
標準包裝: 7
應用: 數據傳輸
接口: 串行
電源電壓: 1.8V,2.5V,3.3V
封裝/外殼: 100-LFBGA,CSPBGA
供應商設備封裝: 100-CSBGA(10x10)
包裝: 托盤
安裝類型: 表面貼裝
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁當前第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁第154頁第155頁第156頁第157頁第158頁第159頁第160頁第161頁第162頁第163頁第164頁第165頁第166頁第167頁第168頁第169頁第170頁第171頁第172頁
DS33Z11 Ethernet Mapper
18 of 172
NAME
PIN #
DS33Z11
CSBGA
(169)
PIN #
DS33ZH1
1
BGA(100)
TYPE
FUNCTION
RDEN/
RBSYNC
H2
I
Receive Data Enable: The receive data enable is
programmable to block the receive data. The RDEN must
be coincident with the RSER data bit to be blocked or
enabled. The active polarity of RDEN is programmable in
register LI.RSLCR. It is recommended for both T1/E1 and
T3/E3 applications that use gapped clocks. The RDEN
signal is provided for interfacing to framers that do not
have a gapped clock facility.
Receive Byte Synchronization Input: Provides byte
synchronization input to X.86 decoder. This signal will go
high at the first bit of the byte as it arrives. This signal can
occur at maximum rate every 8 bits. Note that a long as
the Z11 receives one RBSYNC indicator. The X.86
receiver will determine the byte boundary. Hence the Z11
does not require a continuous 8-bit sync indicator. A new
sync pulse is required if the byte boundary changes.
Note that while in Hardware mode with HDLC (non X.86)
operation, this pin must be tied high.
MII/RMII PORT
REF_CLK
D13
I
Reference Clock (RMII and MII): When in RMII mode, all
signals from the PHY are synchronous to this clock input
for both transmit and receive. This required clock can be
up to 50 MHz and should have ±100 ppm accuracy.
When in MII mode in DCE operation, the DS33Z11 uses
this input to generate the RX_CLK and TX_CLK outputs
as required for the Ethernet PHY interface. When the MII
interface is used with DTE operation, this clock is not
required and should be tied low.
In DCE and RMII modes, this input must have a stable
clock input before setting the RST pin high for normal
operation.
REF_CLKO
E13
G10
O
Reference Clock Output (RMII and MII): A derived clock
output up to 50 MHz, generated by internal division of the
SYSCLKI signal. Frequency accuracy of the REF_CLKO
signal will be proportional to the accuracy of the user-
supplied SYSCLKI signal. See Section 8.3.2 for more
information.
TX_CLK
A8
A6
IO
Transmit Clock (MII): Timing reference for TX_EN and
TXD[3:0]. The TX_CLK frequency is 25 MHz for 100 Mbps
operation and 2.5 MHz for 10 Mbps operation.
In DTE mode, this is a clock input provided by the PHY. In
DCE mode, this is an output derived from REF_CLK
providing 2.5 MHz (10 Mbps operation) or 25 MHz (100
Mbps operation).
相關PDF資料
PDF描述
DS34C87TN/NOPB IC LINE DRIVER QUAD CMOS 16-DIP
DS34LV87TMX/NOPB IC LINE DVR QUAD CMOS DIF 16SOIC
DS34S132GN+ IC TDM OVER PACKET 676-BGA
DS34T102GN+ IC TDM OVER PACKET 484TEBGA
DS3501U+H IC POT NV 128POS HV 10-USOP
相關代理商/技術參數
參數描述
DS33ZH11+ 功能描述:網絡控制器與處理器 IC 10/100 ENETXPORT HMODE MAP IND RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發器數量: 數據速率: 電源電流(最大值):595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray
DS34 制造商:LUMILEDS 制造商全稱:LUMILEDS 功能描述:power light source Luxeon V Emitter
DS-3400D UK 制造商:TRUST 功能描述:DESKTOP WIRELESS OPTICAL TRUST
DS3404FP000 制造商:Thomas & Betts 功能描述:30A,PLG,3P4W,MG,404,3P480V
DS3404FP000/JG63 制造商:Thomas & Betts 功能描述:30A,CON,3P4W,MG,404,3P480V,JG63,SC