- 您現在的位置：買賣IC網 > PDF目錄3861 > LPC3250FET296,551 (NXP Semiconductors)IC ARM9 MCU 256K 296-TFBGA PDF資料下載
參數資料
| 型號： | LPC3250FET296,551 |
| 廠商： | NXP Semiconductors |
| 文件頁數： | 24/57頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC ARM9 MCU 256K 296-TFBGA |
| 特色產品： | LPC32x0 ARM926EJ-S Processor |
| 標準包裝： | 126 |
| 系列： | LPC3200 |
| 核心處理器： | ARM9 |
| 芯體尺寸： | 16/32-位 |
| 速度： | 266MHz |
| 連通性： | EBI/EMI，以太網，I²C，IrDA，Microwire，SPI，SSI，SSP，UART/USART，USB OTG |
| 外圍設備： | DMA，I²S，LCD，電機控制 PWM，PWM，WDT |
| 輸入/輸出數： | 51 |
| 程序存儲器類型： | ROMless |
| RAM 容量： | 256K x 8 |
| 電壓 - 電源 (Vcc/Vdd)： | 0.9 V ~ 3.6 V |
| 數據轉換器： | A/D 3x10b |
| 振蕩器型： | 內部 |
| 工作溫度： | -40°C ~ 85°C |
| 封裝/外殼： | 296-TFBGA |
| 包裝： | 托盤 |
| 配用： | 568-4743-ND - KIT LCD TOUCH 5.7" FOR LPC3250 568-4742-ND - MODULE DIMM LPC2478 ARM7 622-1030-ND - KIT LCD TOUCH 5.7" FOR LPC3250 |
| 其它名稱： | 568-4533 935287084551 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁當前第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁
LPC3220_30_40_50
All information provided in this document is subject to legal disclaimers.
NXP B.V. 2011. All rights reserved.
Product data sheet
Rev. 2 — 20 October 2011
30 of 79
NXP Semiconductors
LPC3220/30/40/50
16/32-bit ARM microcontrollers
– extended wait
Power-saving modes dynamically control EMC_CKE[1:0] and EMC_CLK.
Dynamic memory self-refresh mode supported by software.
Controller supports 2 k, 4 k, and 8 k row address synchronous memory parts. That is,
typical 512 MB, 256 MB, 128 MB, and 16 MB parts, with 8, 16, or 32 data bits per
device.
Two reset domains enable dynamic memory contents to be preserved over a soft
reset.
This controller does not support synchronous static memory devices (burst mode
devices).
7.6 AHB master peripherals
The LPC3220/30/40/50 implements four AHB master peripherals, which include a
General Purpose Direct Memory Access (GPDMA) controller, a 10/100 Ethernet Media
Access Controller (MAC), a Universal Serial Bus (USB) controller, and an LCD controller.
Each of these four peripherals contain an integral DMA controller optimized to support the
performance demands of the peripheral.
7.6.1 General Purpose DMA (GPDMA) controller
The GPDMA controller allows peripheral-to memory, memory-to-peripheral,
peripheral-to-peripheral, and memory-to-memory transactions. Each DMA stream
provides unidirectional serial DMA transfers for a single source and destination. For
example, a bidirectional port requires one stream for transmit and one for receive. The
source and destination areas can each be either a memory region or a peripheral, and
can be accessed through the same AHB master, or one area by each master. The DMA
controller supports the following peripheral device transfers.
Secure Digital (SD) Memory interface
High-speed UARTs
I2S0 and I2S1 ports
SPI1 and SPI2 interfaces
SSP0 and SSP1 interfaces
Memory
The DMA controls eight DMA channels with hardware prioritization. The DMA controller
interfaces to the system via two AHB bus masters, each with a full 32-bit data bus width.
DMA operations may be set up for 8-bit, 16-bit, and 32-bit data widths, and can be either
big-endian or little-endian. Incrementing or non-incrementing addressing for source and
destination are supported, as well as programmable DMA burst size. Scatter or gather
DMA is supported through the use of linked lists. This means that the source and
destination areas do not have to occupy contiguous areas of memory.
7.6.2 Ethernet MAC
The Ethernet block contains a full featured 10 Mbit/s or 100 Mbit/s Ethernet MAC
designed to provide optimized performance through the use of DMA hardware
acceleration. Features include a generous suite of control registers, half or full duplex
operation, flow control, control frames, hardware acceleration for transmit retry, receive
相關PDF資料 |
PDF描述 |
|---|---|
| P89V51RB2FA,529 | IC 80C51 MCU FLASH 16K 44-PLCC |
| P89V660FA,512 | IC 80C51 MCU FLASH 16K 44-PLCC |
| P89V660FBC,557 | IC 80C51 MCU FLASH 16K 44-TQFP |
| P89V662FBC,557 | IC 80C51 MCU FLASH 32K 44-TQFP |
| PIC32MX130F064B-I/SO | IC MCU 32BIT 64KB FLASH 28-SOIC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LPC-35 | 功能描述:LED電源 RoHS:否 制造商:Cree, Inc. 工作模式:Constant Voltage (CV) 輸出功率額定值: 輸入電壓:220 V to 240 V 輸出端數量:1 輸出電壓（通道 1）:40 V 輸出電流（通道 1）:900 mA 安裝風格:Screw 尺寸:90 mm L x 90 mm W x 37.5 mm H 商用/醫用:Commercial |
| LPC-35_11 | 制造商:MEANWELL 制造商全稱:Mean Well Enterprises Co., Ltd. 功能描述:35W Single Output Switching Power Supply |
| LPC-35_12 | 制造商:MEANWELL 制造商全稱:Mean Well Enterprises Co., Ltd. 功能描述:35W Single Output Switching Power Supply |
| LPC-35-1050 | 功能描述:LED電源 31.5W 30V 1050mA RoHS:否 制造商:Cree, Inc. 工作模式:Constant Voltage (CV) 輸出功率額定值: 輸入電壓:220 V to 240 V 輸出端數量:1 輸出電壓（通道 1）:40 V 輸出電流（通道 1）:900 mA 安裝風格:Screw 尺寸:90 mm L x 90 mm W x 37.5 mm H 商用/醫用:Commercial |
| LPC-35-1400 | 功能描述:LED電源 33.6W 24V 1400mA RoHS:否 制造商:Cree, Inc. 工作模式:Constant Voltage (CV) 輸出功率額定值: 輸入電壓:220 V to 240 V 輸出端數量:1 輸出電壓（通道 1）:40 V 輸出電流（通道 1）:900 mA 安裝風格:Screw 尺寸:90 mm L x 90 mm W x 37.5 mm H 商用/醫用:Commercial |
發布緊急采購，3分鐘左右您將得到回復。