- 您現在的位置：買賣IC網 > PDF目錄1909 > CS8952-IQZ (Cirrus Logic Inc)IC TXRX 100/10 PHY 100TQFP PDF資料下載
參數資料
| 型號： | CS8952-IQZ |
| 廠商： | Cirrus Logic Inc |
| 文件頁數： | 20/81頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC TXRX 100/10 PHY 100TQFP |
| 標準包裝： | 90 |
| 類型： | 收發器 |
| 規程： | MII |
| 電源電壓： | 4.75 V ~ 5.25 V |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 100-LQFP |
| 供應商設備封裝： | 100-TQFP（14x14） |
| 包裝： | 托盤 |
| 產品目錄頁面： | 759 (CN2011-ZH PDF) |
| 其它名稱： | 598-1208 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁當前第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁
CS8952
CrystalLAN 100BASE-X and 10BASE-T Transceiver
27
DS206F1
onto RXD[3:0] synchronously with respect to
RX_CLK.
Receive errors are indicated during frame reception
by the assertion of RX_ER. It indicates that an error
was detected somewhere in the frame currently be-
ing transferred across the MII. RX_ER will transi-
tion synchronously with respect to the RX_CLK,
and will be held high for one cycle for each error re-
ceived. It is up to the MAC to ensure that a CRC er-
ror is detected in that frame by the Logical Link
Control. Figure 2 illustrates reception without er-
rors, and Figure 3 illustrates reception with errors.
4.3
MII Transmit Data
TX_EN is used by the MAC to signal to the
CS8952 that valid nibbles of data are being present-
ed across the MII via TXD[3:0]. TX_EN must be
asserted synchronously with the first nibble of pre-
amble, and must remain asserted as long as valid
data is being presented to the MII.
TX_EN must be de-asserted within one TX_CLK
cycle after the last nibble of data (CRC) has been
presented to the CS8952. When TX_EN is not as-
serted, data on TXD[3:0] is ignored.
Transmit errors should be signaled by the MAC by
asserting TX_ER for one or more TX_CLK cycles.
TX_ER must be synchronous with TX_CLK. This
will cause the CS8952 to replace the nibble with a
HALT symbol in the frame being transmitted. This
invalid data will be detected by the receiving PHY
and flagged as a bad frame. Figure 4 illustrates
transmission without errors, and Figure 5 illustrates
transmission with errors.
4.4
MII Management Interface
The CS8952 provides an enhanced IEEE 802.3 MII
Management Interface. The interface consists of
three signals: a bi-directional serial data line
(MDIO), a data clock (MDC), and an optional in-
terrupt signal (MII_IRQ). The Management Inter-
face can be used to access status and control
registers internal to the CS8952. The CS8952 im-
plements an extended set of 16-bit MII registers.
Eight of the registers are defined by the IEEE 802.3
RX_CLK
RX_DV
RXD[3:0]
RX_ER
Preamble/SFD
DATA
Figure 2. Reception without errors
RX_CLK
RX_DV
RXD[3:0]
RX_ER
Preamble/SFD
DATA
XX
DATA
Figure 3. Reception with errors
相關PDF資料 |
PDF描述 |
|---|---|
| CY8CLED04DOCD1-56LTXI | IC POWERPSOC DEBUG 4CH 1A 56VQFN |
| CYG2217 | IC MOD PHONE LINE WIRE 1.07" PCB |
| DAC312ER | IC DAC 12BIT MULT HS 20-CDIP |
| DAC8143FPZ | IC DAC 12BIT DAISYCHAIN 16DIP |
| DAC8228FSZ | IC DAC 8BIT DUAL V-OUT 20SOIC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| CS8952-IQZR | 功能描述:以太網 IC IC 100BASE-TX and 10BASE-T Transceiver RoHS:否 制造商:Micrel 產品:Ethernet Switches 收發器數量:2 數據速率:10 Mb/s, 100 Mb/s 電源電壓-最大:1.25 V, 3.45 V 電源電壓-最小:1.15 V, 3.15 V 最大工作溫度:+ 85 C 封裝 / 箱體:QFN-64 封裝:Tray |
| CS8952T | 制造商:CIRRUS 制造商全稱:Cirrus Logic 功能描述:100BASE E-X AND 10BASE-T TRANSCEIVER |
| CS8952T-CQ | 制造商:CIRRUS 制造商全稱:Cirrus Logic 功能描述:100BASE E-X AND 10BASE-T TRANSCEIVER |
| CS8952T-IQ | 制造商:CIRRUS 制造商全稱:Cirrus Logic 功能描述:100BASE E-X AND 10BASE-T TRANSCEIVER |
| CS8952T-IQR | 制造商:Cirrus Logic 功能描述:ETHERNET TXRX SGL CHIP 1-PORT 5V 10MBPS/100MBPS 100TQFP - Tape and Reel |
發布緊急采購，3分鐘左右您將得到回復。