- 您現在的位置：買賣IC網 > PDF目錄16185 > LMK04000BEVALXO (National Semiconductor)BOARD EVAL PREC CLOCK PLL XO PDF資料下載
參數資料
| 型號： | LMK04000BEVALXO |
| 廠商： | National Semiconductor |
| 文件頁數： | 28/65頁 |
| 文件大?。?/td> | 0K |
| 描述： | BOARD EVAL PREC CLOCK PLL XO |
| 標準包裝： | 1 |
| 系列： | PowerWise® |
| 主要目的： | 計時，時鐘調節器 |
| 嵌入式： | 否 |
| 已用 IC / 零件： | LMK04000 |
| 主要屬性： | 122.88 MHz 晶體 |
| 次要屬性： | 集成式 PLL 和 VCO |
| 已供物品： | 板，線纜 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁當前第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁
N
R
X FOSCin
(VCO_DIV CLK_DIV)
FCLK error =
N
R
FOSCin
(VCO_DIV CLK_DIV)
FCLK =
SNOSAZ8J – SEPTEMBER 2008 – REVISED SEPTEMBER 2011
CLKoutX_MUX: Clock Output Mux
The output of each CLKoutX channel pair is controlled by its' channel multiplexer (mux). The mux can select
between several signals: bypassed, divided only, divided and delayed, or delayed only.
Table 10. CLKoutX_MUX: Clock Channel Multiplexer Control Bits
CLKout_MUX [1:0]
Clock Mode
b1
b0
0
Bypassed
0
1
Divided
1
0
Delayed
1
Divided and Delayed
Registers 5, 6
These registers are reserved. These register values should not be modified from the values shown in the register
map.
Register 7
Reset bit
This bit is only in register R7. The use of this bit is optional and it should be set to '0' if not used. Setting this bit
to a '1' forces all registers to their power on reset condition and therefore automatically clears this bit.
Registers 8, 9
These registers are reserved. These register values should not be modified from the values shown in the register
map.
Register 10
RC_DLD1_Start: PLL1 Digital Lock Detect Run Control bit
This bit is used to control the state machine for the PLL2 VCO tuning algorithm. The following table describes the
function of this bit.
Table 11. RC_DLD1_Start bit States
RC_DLD1_Start
Description
1
The PLL2 VCO tuning algorithm trigger is delayed until PLL1 Digital Lock Detect is valid.
0
The PLL2 VCO tuning algorithm runs immediately after any PLL2_N counter update, despite the state of PLL1
Digital Lock Detect.
If the user is unsure of the state of the reference clock input at startup of the LMK040xx device, setting
RC_DLD1_Start = 0 will allow PLL2 to tune and lock the internal VCO to the oscillator attached to the OSCin
port. This ensures that the active clock outputs will start up at frequencies close to their desired values. The error
in clock output frequency will depend on the open loop accuracy of the oscillator driving the OSCin port. The
frequency of an active clock output is normally given by:
If the open loop frequency accuracy of the external oscillator (either a VCXO or crystal based oscillator) is "X"
ppm, then the error in the output clock frequency (FCLK error) will be:
34
Copyright 2008–2011, Texas Instruments Incorporated
相關PDF資料 |
PDF描述 |
|---|---|
| 380LX822M063A032 | CAP ALUM 8200UF 63V 20% SNAP |
| A3CKB-3036M | IDC CABLE - AKC30B/AE30M/APK30B |
| 381LX391M400A042 | CAP ALUM 390UF 400V 20% SNAP |
| ECM06DTMN-S664 | CONN EDGECARD 12POS R/A .156 |
| M3UYK-2606J | IDC CABLE - MKS26K/MC26G/MPD26K |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LMK04000BISQ | 制造商:NSC 制造商全稱:National Semiconductor 功能描述:Low-Noise Clock Jitter Cleaner with Cascaded PLLs |
| LMK04000BISQ/NOPB | 功能描述:時鐘合成器/抖動清除器 RoHS:否 制造商:Skyworks Solutions, Inc. 輸出端數量: 輸出電平: 最大輸出頻率: 輸入電平: 最大輸入頻率:6.1 GHz 電源電壓-最大:3.3 V 電源電壓-最小:2.7 V 封裝 / 箱體:TSSOP-28 封裝:Reel |
| LMK04000BISQE | 制造商:Texas Instruments 功能描述:Clock Conditioner 48-Pin LLP EP T/R |
| LMK04000BISQE/NOPB | 功能描述:時鐘合成器/抖動清除器 RoHS:否 制造商:Skyworks Solutions, Inc. 輸出端數量: 輸出電平: 最大輸出頻率: 輸入電平: 最大輸入頻率:6.1 GHz 電源電壓-最大:3.3 V 電源電壓-最小:2.7 V 封裝 / 箱體:TSSOP-28 封裝:Reel |
| LMK04000BISQX | 制造商:NSC 制造商全稱:National Semiconductor 功能描述:Low-Noise Clock Jitter Cleaner with Cascaded PLLs |
發布緊急采購，3分鐘左右您將得到回復。