- 您現在的位置：買賣IC網 > PDF目錄171234 > DSPA56371 (飛思卡爾半導體(中國)有限公司) SigmaDSP 28-/56-Bit Audio Processor with Two ADCs and Four DACs PDF資料下載
參數資料
| 型號： | DSPA56371 |
| 廠商： | 飛思卡爾半導體(中國)有限公司 |
| 元件分類： | 數字信號處理 |
| 英文描述： | SigmaDSP 28-/56-Bit Audio Processor with Two ADCs and Four DACs |
| 中文描述： | SigmaDSP的28-/56-Bit音頻處理器雙ADC和4個DAC |
| 文件頁數： | 56/124頁 |
| 文件大?。?/td> | 1752K |
| 代理商： | DSPA56371 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁當前第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁
Reset, Stop, Mode Select, and Interrupt Timing
Freescale Semiconductor
DSP56371 Technical Data
37
Figure 5.
Reset Timing
21
Interrupt Requests Rate
ESAI, ESAI_1, SHI, DAX, Timer
12 x TC
——
ns
DMA
8 x TC
——
ns
IRQ, NMI (edge trigger)
8 x TC
——
ns
IRQ (level trigger)
12 c TC
——
ns
22
DMA Requests Rate
Data read from ESAI, ESAI_1, SHI, DAX
6 x TC
—
ns
Data write to ESAI, ESAI_1, SHI, DAX
7 x TC
——
ns
Timer
2 x TC
——
ns
IRQ, NMI (edge trigger)
3 x TC
——
ns
Notes:
1. When using fast interrupts and IRQA, IRQB, IRQC, and IRQD are defined as level-sensitive, timings 19 through 21 apply
to prevent multiple interrupt service. To avoid these timing restrictions, the deasserted Edge-triggered mode is
recommended when using fast interrupts. Long interrupts are recommended when using Level-sensitive mode.
2. For PLL disable, using external clock (PCTL Bit 13 = 0), no stabilization delay is required and recovery time will be
defined by the OMR Bit 6 settings.
For PLL enable, (if bit 12 of the PCTL register is 0), the PLL is shutdown during Stop. Recovering from Stop requires the
PLL to get locked. The PLL lock procedure duration, PLL Lock Cycles (PLC), may be in the range of 0.5 ms.
3. Periodically sampled and not 100% tested
4. RESET duration is measured during the time in which RESET is asserted, VDD is valid, and the EXTAL input is active
and valid. When the VDD is valid, but the other “required RESET duration” conditions (as specified above) have not been
yet met, the device circuitry will be in an uninitialized state that can result in significant power consumption and heat-up.
Designs should minimize this state to the shortest possible duration.
Table 19. Reset, Stop, Mode Select, and Interrupt Timing (Continued)
No.
Characteristics
Expression
Min
Max
Unit
VIH
RESET
Reset Value
All Pins
10
11
13
相關PDF資料 |
PDF描述 |
|---|---|
| DSR-09 | PIANO DIP SWITCH-9SWITCHES, SPST, LATCHED,0.05A, 24VDC, THROUGH HOLE-STRAIGHT |
| DA-12 | PIANO DIP SWITCH-12SWITCHES, SPST, LATCHED,0.05A, 24VDC, THROUGH HOLE-RIGHT ANGLE |
| DP-10T | PIANO DIP SWITCH-10SWITCHES, SPST, LATCHED,0.05A, 24VDC, THROUGH HOLE-RIGHT ANGLE |
| DS-03T | PIANO DIP SWITCH-3SWITCHES, SPST, LATCHED,0.05A, 24VDC, THROUGH HOLE-STRAIGHT |
| DS-06 | PIANO DIP SWITCH-6SWITCHES, SPST, LATCHED,0.05A, 24VDC, THROUGH HOLE-STRAIGHT |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DSPA56371AF150 | 制造商:Freescale Semiconductor 功能描述:DSP FIXED-POINT 24-BIT 150MHZ 150MIPS 80-PIN LQFP TRAY - Trays |
| DSPA56371AF180 | 制造商:Freescale Semiconductor 功能描述:DSP FIXED-POINT 24-BIT 181MHZ 181MIPS 80-PIN LQFP TRAY - Trays |
| DSPA56720AG | 制造商:Freescale Semiconductor 功能描述:DSP FIXED-POINT 24-BIT 200MHZ 200MIPS 144-PIN LQFP TRAY - Trays |
| DSPA56721AF | 制造商:Freescale Semiconductor 功能描述:DSP FIXED-POINT 24-BIT 200MHZ 200MIPS 80-PIN LQFP TRAY - Bulk |
| DSPA56721AG | 制造商:Freescale Semiconductor 功能描述:AUD PROCESSOR 144LQFP - Bulk |
發布緊急采購，3分鐘左右您將得到回復。