- 您現在的位置：買賣IC網 > PDF目錄373631 > TFRA08C13 (Lineage Power) Ultraframer DS3/E3/DS2/E2/DS1/E1/DS0 PDF資料下載
參數資料
| 型號： | TFRA08C13 |
| 廠商： | Lineage Power |
| 元件分類： | 通信及網絡 |
| 英文描述： | Ultraframer DS3/E3/DS2/E2/DS1/E1/DS0 |
| 中文描述： | Ultraframer DS3/E3/DS2/E2/DS1/E1/DS0 |
| 文件頁數： | 61/188頁 |
| 文件大?。?/td> | 3047K |
| 代理商： | TFRA08C13 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁當前第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁第154頁第155頁第156頁第157頁第158頁第159頁第160頁第161頁第162頁第163頁第164頁第165頁第166頁第167頁第168頁第169頁第170頁第171頁第172頁第173頁第174頁第175頁第176頁第177頁第178頁第179頁第180頁第181頁第182頁第183頁第184頁第185頁第186頁第187頁第188頁
Lucent Technologies Inc.
61
Preliminary Data Sheet
October 2000
TFRA08C13 OCTAL T1/E1 Framer
CEPT Time Slot 0 FAS/NOT FAS Control
Bits
(continued)
Interrupts indicating that the transmit Sa stack or the
receive Sa stack are ready for system access are avail-
able, see register FRM_SR4 bit 6 and bit 7.
CEPT Time Slot 16 X0—X2 Control Bits
Each of the three X bits in frame 0 of the time slot 16
multiframe can be used as a 0.5 kbits/s data link to and
from the remote end. The transmitted line X bits are
sourced from control register FRM_PR41 bit 0—bit 2.
In the loss of TS16 multiframe alignment (LTS16MFA)
state, receive X bits are set to 1 in status register
FRM_SR53.
Signaling Access
Signaling information can be accessed by three differ-
ent methods: transparently through the CHI, via the
control registers, or via the CHI associated signaling
mode.
Transparent Signaling
This mode is enabled by setting register FRM_PR44 bit
0 to 1.
Data at the received RCHIDATA interface passes
through the framer undisturbed. The framer generates
an arbitrary signaling multiframe in the transmit and
receive directions to facilitate the access of signaling
information at the system interface.
DS1: Robbed-Bit Signaling
Microprocessor Control Registers
To enable signaling, register FRM_PR44 bit 0 must be
set to 0 (default).
The information written into the F and G bits of the
transmit signaling registers, FRM_TSR0—
FRM_TSR23, define the robbed-bit signaling mode for
each channel for both the transmit and receive direc-
tions. The per-channel programming allows the system
to combine voice channels with data channels within
the same frame.
The receive-channel robbed-bit signaling mode is
always defined by the state of the F and G bits in the
corresponding transmit signaling registers for that
channel. The received signaling data is stored in the
receive signaling registers, FRM_RSR0—
FRM_RSR23, while receive framer is in both the frame
and superframe alignment states. Updating the receive
signaling registers can be inhibited on-demand, by set-
ting register FRM_PR44 bit 3 to 1, or automatically
when either a framing error event, a loss of frame, or
superframe alignment state is detected or a controlled
slip event occurs. The signaling inhibit state is valid for
at least 32 frames after any one of the following: a
framing errored event, a loss of frame and/or super-
frame alignment state, or a controlled slip event.
In the common channel signaling mode, data written in
the transmit signaling registers is transmitted in chan-
nel 24 of the transmit line bit stream. The F and G bits
are ignored in this mode. The received signaling data
from channel 24 is stored in receive signaling registers
FRM_RSR0—FRM_RSR23 for T1.
Associated Signaling Mode
This mode is enabled by setting register FRM_PR44 bit
2 to 1.
Signaling information in the associated signaling mode
(ASM) is allocated an 8-bit system time slot in conjunc-
tion with the payload data information for a particular
channel. The default system data rate in the ASM
mode is 4.096 Mbits/s. Each system channel consists
of an 8-bit payload time slot followed by its correspond-
ing 8-bit signaling time slot. The format of the signaling
byte is identical to that of the signaling registers.
In the ASM mode, writing the transmit signaling regis-
ters will corrupt the transmit signaling data. In the trans-
mit signaling register ASM (TSR-ASM) format, enabled
by setting register FRM_PR44 bit 2 and bit 5 to 1, the
system must write into the F and G bit
*
of the transmit
signaling registers to program the robbed-bit signaling
state mode of each DS0. The ABCD bits are sourced
from the RCHI ports when TSR-ASM mode is enabled.
* All other bits in the signaling registers are ignored, while the F and
G bits in the received RCHIDATA stream are ignored.
相關PDF資料 |
PDF描述 |
|---|---|
| TFS380C | VI TELEFILTER Filter specification |
| TFT0675F | Anti-Aliasing and Reconstruction TFT range |
| TFT0675S | Anti-Aliasing and Reconstruction TFT range |
| TFT1350F | Anti-Aliasing and Reconstruction TFT range |
| TFT1350S | Anti-Aliasing and Reconstruction TFT range |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TFRA08C13-DB | 制造商:AGERE 制造商全稱:AGERE 功能描述:TFRA08C13 OCTAL T1/E1 Framer |
| TFRA28J133BAL-1 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Telecomm/Datacomm |
| TFRA84J13 | 制造商:AGERE 制造商全稱:AGERE 功能描述:Ultraframer DS3/E3/DS2/E2/DS1/E1/DS0 |
| TFRA84J131BL-3-DB | 制造商:LSI Corporation 功能描述:Framer DS0/DS1/DS2/DS3/E1/E2/E3 1.5V/3.3V 909-Pin BGA |
| TFRA84J13DS0 | 制造商:AGERE 制造商全稱:AGERE 功能描述:Ultraframer DS3/E3/DS2/E2/DS1/E1/DS0 |
發布緊急采購，3分鐘左右您將得到回復。