參數資料
型號: XRT86VL3X
廠商: Exar Corporation
元件分類: 通信及網絡
英文描述: Ultraframer DS3/E3/DS2/E2/DS1/E1/DS0
中文描述: Ultraframer DS3/E3/DS2/E2/DS1/E1/DS0
文件頁數: 43/149頁
文件大?。?/td> 1274K
代理商: XRT86VL3X
XRT86VL3X
36
REV. 1.2.0
T1/E1/J1 FRAMER/LIU COMBO - ARCHITECTURE DESCRIPTION
Figure 36
below shows the timing diagram of the output signals associated with the DS1 Receive Overhead
Output Interface module in N or SLC96 framing format mode.
3.2.4
Configure the DS1 Receive Overhead Output Interface module as destination of the Remote
Signaling (R) bits in T1DM framing format mode
The R bits in T1DM framing format mode can be extracted to:
DS1 Receive Overhead Output Interface Block
DS1 Receive HDLC Controller
DS1 Receive Serial Output Interface.
The Receive Data Link Source Select bits of the Receive Data Link Select Register (RDLSR) controls the
destination of R bits in T1DM framing format mode. The table below shows configuration of the Receive Data
Link Source Select bits of the Receive Data Link Select Register (RDLSR).
If the Receive Data Link Source Select bits of the Receive Data Link Select Register are set to 10, the Receive
Overhead Output Interface Block outputs the R bits extracted from the incoming T1 data stream. Since R bit
presents in Timeslot 24 of every T1DM frame, therefore, bandwidth of T1DM data link channel is 8KHz.
F
IGURE
36. DS1 R
ECEIVE
O
VERHEAD
O
UTPUT
I
NTERFACE
T
IMING
IN
N
OR
SLC96 F
RAMING
F
ORMAT
MODE
RECEIVE DATA LINK SELECT REGISTER (RDLSR) (ADDRESS = 0XN10AH)
B
IT
N
UMBER
B
IT
N
AME
B
IT
T
YPE
B
IT
D
ESCRIPTION
1-0
Receive Data Link
Source Select
R/W
00 - The extracted Facility Data Link bits are stored in either the LAPD con-
troller or the SLC
96 buffer. At the same time, the extracted Facility Data
Link bits are outputted from the framer through the Receive Serial Data
Output Interface via the RxSer_n pins.
01 - The extracted Facility Data Link bits are outputted from the framer
through the Receive Serial Data Output Interface via the RxSer_n pins.
10 - The extracted Facility Data Link bits are outputted from the framer
through the Receive Overhead Output Interface via the RxOH_n pins. At
the same time, the extracted Facility Data Link bits are outputted from the
framer through the Receive Serial Data Output Interface via the RxSer_n
pins.
11 - The Facility Data Link bits are forced to one by the framer.
相關PDF資料
PDF描述
XRT91L30_0611 STS-12/STM-4 OR STS-3/STM-1 SONET/SDH TRANSCEIVER
XRT91L306 STS-12/STM-4 OR STS-3/STM-1 SONET/SDH TRANSCEIVER
XRT91L30IQ STS-12/STM-4 OR STS-3/STM-1 SONET/SDH TRANSCEIVER
XRT91L30 STS-12/STM-4 OR STS-3/STM-1 SONET/SDH TRANSCEIVER
XRT91L31 STS-12/STM-4 OR STS-3/STM-1 SONET/SDH TRANSCEIVER
相關代理商/技術參數
參數描述
XRT86VL3X_07 制造商:EXAR 制造商全稱:EXAR 功能描述:T1/E1/J1 FRAMER/LIU COMBO - ARCHITECTURE DESCRIPTION
XRT86VL3X_0710 制造商:EXAR 制造商全稱:EXAR 功能描述:T1/E1/J1 FRAMER/LIU COMBO - ARCHITECTURE DESCRIPTION
XRT86VX38 制造商:EXAR 制造商全稱:EXAR 功能描述:OCTAL T1/E1/J1 FRAMER/LIU COMBO - HARDWARE DESCRIPTION
XRT86VX38_09 制造商:EXAR 制造商全稱:EXAR 功能描述:8-CHANNEL T1/E1/J1 FRAMER/LIU COMBO - T1 REGISTER DESCRIPTION
XRT86VX38_0906 制造商:EXAR 制造商全稱:EXAR 功能描述:OCTAL T1/E1/J1 FRAMER/LIU COMBO - HARDWARE DESCRIPTION