![](http://datasheet.mmic.net.cn/180000/MT47H128M8HV-187ELIT-E_datasheet_11334050/MT47H128M8HV-187ELIT-E_23.png)
Electrical Specifications – Absolute Ratings
Stresses greater than those listed may cause permanent damage to the device. This is a
stress rating only, and functional operation of the device at these or any other condi-
tions outside those indicated in the operational sections of this specification is not
implied. Exposure to absolute maximum rating conditions for extended periods may
affect reliability.
Table 5: Absolute Maximum DC Ratings
Parameter
Symbol
Min
Max
Units
Notes
VDD supply voltage relative to VSS
VDD
–1.0
2.3
V
VDDQ supply voltage relative to VSSQ
VDDQ
–0.5
2.3
V
VDDL supply voltage relative to VSSL
VDDL
–0.5
2.3
V
Voltage on any ball relative to VSS
VIN, VOUT
–0.5
2.3
V
Input leakage current; any input 0V
≤ VIN ≤ VDD; all other
balls not under test = 0V
II
–5
5
A
Output leakage current; 0V
≤ VOUT ≤ VDDQ; DQ and ODT dis-
abled
IOZ
–5
5
A
VREF leakage current; VREF = Valid VREF level
IVREF
–2
2
A
Notes: 1. VDD, VDDQ, and VDDL must be within 300mV of each other at all times; this is not re-
quired when power is ramping down.
2. VREF ≤ 0.6 × VDDQ; however, VREF may be ≥ VDDQ provided that VREF ≤ 300mV.
3. Voltage on any I/O may not exceed voltage on VDDQ.
Temperature and Thermal Impedance
It is imperative that the DDR2 SDRAM device’s temperature specifications, shown in
proper operating range to meet data sheet specifications. An important step in maintain-
ing the proper junction temperature is using the device’s thermal impedances correct-
available die revision and packages.
Incorrectly using thermal impedances can produce significant errors. Read Micron tech-
listed in
Table 7. For designs that are expected to last several years and require the flexi-
bility to use several DRAM die shrinks, consider using final target theta values (rather
than existing values) to account for increased thermal impedances from the die size re-
duction.
The DDR2 SDRAM device’s safe junction temperature range can be maintained when
the TC specification is not exceeded. In applications where the device’s ambient temper-
ature is too high, use of forced air and/or heat sinks may be required in order to satisfy
the case temperature specifications.
1Gb: x4, x8, x16 DDR2 SDRAM
Electrical Specifications – Absolute Ratings
PDF: 09005aef821ae8bf
1GbDDR2.pdf – Rev. S 10/09 EN
23
Micron Technology, Inc. reserves the right to change products or specifications without notice.
2004 Micron Technology, Inc. All rights reserved.