- 您現在的位置：買賣IC網 > PDF目錄359234 > MT90520 (Zarlink Semiconductor Inc.) 8-Port Primary Rate Circuit Emulation AAL1 SAR PDF資料下載
參數資料
| 型號： | MT90520 |
| 廠商： | Zarlink Semiconductor Inc. |
| 英文描述： | 8-Port Primary Rate Circuit Emulation AAL1 SAR |
| 中文描述： | 8端口基本速率電路仿真AAL1特區 |
| 文件頁數： | 48/180頁 |
| 文件大?。?/td> | 1736K |
| 代理商： | MT90520 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁當前第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁第154頁第155頁第156頁第157頁第158頁第159頁第160頁第161頁第162頁第163頁第164頁第165頁第166頁第167頁第168頁第169頁第170頁第171頁第172頁第173頁第174頁第175頁第176頁第177頁第178頁第179頁第180頁
MT90520
Data Sheet
48
Zarlink Semiconductor Inc.
Silence Insertion
During an underrun condition bit 10 of TDM Control Register 3, REPLAY_N_SILENCE, is used to indicate whether
old data or a silence byte will be played out onto the TDM bus signal DSTo. This bit is programmable on a per port
basis. When the bit is set to 1 or REPLAY, old data from the reassembly circular buffer will be played out. When the
bit is set to 0 or SILENCE, a programmable silence byte is played out onto the DSTo channel. The silence byte to
be played out is programmed into the Main TDM Control Register 1, bits <15:8>.
When an active channel is mis-reporting an underrun condition the REPLAY_N_SILENCE bit still controls what
data is played out onto the TDM bus. If this bit is set to 1 for REPLAY the correct data will be played out. If the bit is
set to 0 for SILENCE then the silence byte will be played out rather than the correct data. As such, for bit error free
operation, the REPLAY option must be selected for any TDM port where an active channel is mis-reporting an
underrun condition.
Inactive Channels
A recommended solution would be to open a dummy receive VC(s) containing up to 128 inactive channels. This will
increase the prospect that active channels (x) will not mis-report underrun as more (x+4) channels will be active.
The procedure would be as follows
To open a valid receive VC - mask TDM interrupts, close the dummy receive VC(s), open the valid receive
VC, re-open the dummy receive VC(s) (with less channels), unmask the TDM interrupts
To close a valid receive VC - mask TDM interrupts, close the valid receive VC, close the dummy receive
VC(s), re-open the dummy receive VC(s) (with more channels), unmask the TDM interrupts
4.3.2.3 TDM Loopback
There are two loopback modes implemented in the TDM module.
TDM Low-Latency Loopback
The first loopback mode is TDM low-latency loopback, and is enabled by setting the TDM_LOW_LATENCY_LPBK
bit in a port’s TDM Control Register 1. When this bit is set, the TDM data coming in on DSTi is directly output on the
DSTo output line of the same TDM port, with a delay through the device of about two TDM clock cycles.
TDM Circular Buffer Loopback (SDT Mode)
The second loopback is performed at the Circular Buffer level. It can only be used in SDT mode and it is selected by
setting the TDM_CIR_BUF_LPBK bit in a port’s TDM Control Register 1. In this loopback mode, the TDM SDT
reassembly process uses the TDM_SEGMEN_BASE_ADD (in the per-port TDM Control Register 2) as the base
address for the SDT Reassembly Circular Buffers in external memory. This loopback mode can be used to:
loop back an entire stream
loop back certain channels while tristating others
switch the data between various channels (within the same port)
To determine which channels to loop back and their order, the TDM reassembly process reads the TDM SDT
Reassembly Control Structure (refer to Figure 13 on page 46), which should be programmed in the following
manner:
V -
The valid bits should be set for those channels which should be output on DSTo/CSTo. If the valid bit for
a channel is not set, the output channel is tristated.
SU, I, and PU bits -
These bits should be cleared.
Reassembly Circular Buffer Address bits -
bits<9:6> - These bits should be cleared as they are not used in loopback mode.
相關PDF資料 |
PDF描述 |
|---|---|
| MT90520AG | 8-Port Primary Rate Circuit Emulation AAL1 SAR |
| MT9072 | Ultraframer DS3/E3/DS2/E2/DS1/E1/DS0 |
| MT9072AB | Ultraframer DS3/E3/DS2/E2/DS1/E1/DS0 |
| MT9072AV | Ultraframer DS3/E3/DS2/E2/DS1/E1/DS0 |
| MT90820 | Large Digital Switch |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MT90520AG | 制造商:Microsemi Corporation 功能描述:ATM SAR 2.048MBPS 2.5V CBR 456BGA - Trays |
| MT90520AG2 | 制造商:Microsemi Corporation 功能描述:ATM SAR 2.048MBPS 2.5V CBR 456BGA - Trays 制造商:Zarlink Semiconductor Inc 功能描述:ATM SAR 2.048MBPS 2.5V CBR 456BGA - Trays |
| MT90528 | 制造商:ZARLINK 制造商全稱:Zarlink Semiconductor Inc 功能描述:28-Port Primary Rate Circuit Emulation AAL1 SAR |
| MT90528AG | 制造商:ZARLINK 制造商全稱:Zarlink Semiconductor Inc 功能描述:28-Port Primary Rate Circuit Emulation AAL1 SAR |
| MT90528AG2 | 制造商:ZARLINK 制造商全稱:Zarlink Semiconductor Inc 功能描述:28-Port Primary Rate Circuit Emulation AAL1 SAR |
發布緊急采購，3分鐘左右您將得到回復。