- 您現在的位置：買賣IC網 > PDF目錄359147 > MC72000 (飛思卡爾半導體(中國)有限公司) Integrated Bluetooth Radio PDF資料下載
參數資料
| 型號： | MC72000 |
| 廠商： | 飛思卡爾半導體(中國)有限公司 |
| 英文描述： | Integrated Bluetooth Radio |
| 中文描述： | 集成藍牙無線 |
| 文件頁數： | 140/156頁 |
| 文件大小： | 1782K |
| 代理商： | MC72000 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁當前第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁第154頁第155頁第156頁
140
MC72000 Advance Information Data Sheet
Go to: www.freescale.com
MOTOROLA
Applications Information
10.3 External Power Amplifier Enable
The External Power Amplifier Enable (EPAEN) bit, R6/15, can be used in two applications. It may serve
as a complementary driver to a dual-port antenna. This is accomplished when External PA Enable Invert,
R3/10, is set to logic one. In this configuration, EPAEN assumes the inverted value of GPO, which is the
second driver for the antenna switch. EPAEN may also assist in Class 1 operation by setting bit R11/6 to
logic high. This setting allows the MC72000 to drive an external power amplifier. Setting bits R11/6 and
R3/10 to zero disables EPAEN.
10.4 External Power Amplifier DAC
The Bluetooth specification for Class 1 Power implementation requires power control from 4.0 dBm (or
less) to 20 dBm (max) power. The MC72000 external power amplifier digital to analog converter
(EPADRV) output (Pin K6) provides a voltage reference for power control of an external power amplifier
(PA), if desired. The EPADRV output is enabled when External PA DAC Enable (R11/7) is set to one.
Setting R11/7 to zero pulls the EPADRV output to ground. When enabled, the EPADRV output voltage is
controlled by the PA DAC setting (R3/5-0). The minimum EPADRV output voltage is 0 VDC and the
maximum output voltage is 3.2 VDC. The 6-bit resolution of the PA DAC setting corresponds to
approximately 50 mV/bit. When using a VCCRF < 3.2 Vdc, the maximum EPADRV output voltage is
reduced to VCCRF (i.e., the full-scale output of the PA DAC is referenced to 3.2 V). To obtain optimum
functionality of EPADRV with an external PA, this feature should be utilized with the External PA Enable.
Refer to Section 10, “Applications Information,” for additional usage information. The output of the
EPADRV, when enabled, is gated by the MC72000 sequence manager. During a sleep, idle, or RX cycle,
the output is set to zero volts. The programmed value of the output voltage is only achieved during an
active TX cycle as shown in Figure 30.
10.5 PIN Implementation of Antenna Switch
An alternative approach to using an RF switch is to utilize a PIN diode technique as shown in Figure 88.
When both PIN diodes are in the high resistance (i.e., un-biased) state, the transmitter is isolated from the
antenna and LNA input. Conversely, when both PIN diodes are in the low resistance (i.e., forward-biased)
state, the l/4 section appears as an open circuit from the transmitter output to the LNA input, and the
transmitter output is coupled directly to the antenna through the bandpass filter. For receive mode, GPO is
set low. For transmit mode, GPO is set high. Some advantages to this implementation include very low
current consumption while in receive or idle mode, moderate current consumption while in transmit mode,
high receiver isolation, and low cost.
F
Freescale Semiconductor, Inc.
For More Information On This Product,
n
.
相關PDF資料 |
PDF描述 |
|---|---|
| MC7445ARX1000LF | RISC Microprocessor Hardware Specifications |
| MC7445ARX1000LG | RISC Microprocessor Hardware Specifications |
| MC7447A | PowerPC microprocessor |
| MC7447AHX1000NB | PowerPC microprocessor |
| MC7447AHX1167NB | PowerPC microprocessor |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MC7220C-100M RI-BLK | 制造商:Farnell / Pro-Power 功能描述:CABLE DEF 7-2-20C 20CORE 100M 制造商:pro-power 功能描述:CABLE, DEF 7-2-20C, 20CORE, 100M 制造商:pro-power 功能描述:CABLE, DEF 7-2-20C, 20CORE, 100M; Reel Length (Imperial):328ft; Reel Length (Metric):100m; No. of Conductors:20; Voltage Rating:440V; No. of Strands x Strand Size:7 x 0.2mm; Conductor Area CSA:0.22mm2; Jacket Colour:Black; Jacket ;RoHS Compliant: Yes |
| MC7220C-100M RI-BLK | 制造商:Farnell / Pro-Power 功能描述:CABLE DEF 7-2-20C 20 CORE 100M |
| MC7220C-25M RI-BLK | 制造商:Farnell / Pro-Power 功能描述:CABLE DEF 7-2-20C 20CORE 25M 制造商:pro-power 功能描述:CABLE, DEF 7-2-20C, 20CORE, 25M |
| MC7220C-25M RI-BLK | 制造商:Farnell / Pro-Power 功能描述:CABLE DEF 7-2-20C 20 CORE 25M |
| MC7225C-25M RI-BLK | 制造商:Farnell / Pro-Power 功能描述:CABLE DEF 7-2-25C 25CORE 25M 制造商:pro-power 功能描述:MULTICORE, 25, 7/0.2MM, 25M, BLACK 制造商:pro-power 功能描述:CABLE, DEF 7-2-25C, 25CORE, 25M 制造商:PRIVATE LABEL 功能描述:CABLE, DEF 7-2-25C, 25CORE, 25M, Reel Length (Imperial):82ft, Reel Length (Metri |
發布緊急采購，3分鐘左右您將得到回復。