- 您現在的位置：買賣IC網 > PDF目錄69015 > M37920FCCGP 16-BIT, FLASH, 20 MHz, MICROCONTROLLER, PQFP100 PDF資料下載
參數資料
| 型號： | M37920FCCGP |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 16-BIT, FLASH, 20 MHz, MICROCONTROLLER, PQFP100 |
| 封裝： | 14 X 20 MM, 0.65 MM PITCH, PLASTIC, QFP-100 |
| 文件頁數： | 15/158頁 |
| 文件大?。?/td> | 1261K |
| 代理商： | M37920FCCGP |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁當前第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁第154頁第155頁第156頁第157頁第158頁
111
M37920FCCGP, M37920FCCHP
M37920FGCGP, M37920FGCHP
PRELIMINAR
Y
Notice:
This
is not
a final
specification.
Some
parametric
limits
are
subject
to change.
SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER FLASH MEMORY VERSION
MITSUBISHI MICROCOMPUTERS
CLOCK GENERATING CIRCUIT
In the clock generating circuit, the basic clock which is used to oper-
ate the CPU and each internal peripheral device is made by a clock
input from pin XIN. Figure 111 shows the block diagram of the clock
generating circuit. The clock which is input from the external clock in-
put pin, XIN, generates the following;
φ, which is used to operate the microcomputer
φBIU, which is used to operate the BIU
φCPU, which is used to operate the CPU
φ is stopped only when the external clock input is disabled by STP
instruction.
φBIU is stopped when to STP or WIT instruction is ex-
ecuted. Also,
φCPU is stopped when STP or WIT instruction is ex-
ecuted or when a CPU wait request is issued by the BIU.
f1(
φ) is the basic clock for internal peripheral devices. This basic clock
is divided furthermore in the divide circuit, as shown in Figure 111,
and some frequency types are generated. Serial I/O communication
and timer B can use any of four clocks (f2, f16, f64, f512), respectively.
Timer A can use any of six clocks (f2, f16, f64, f512, and f1(
φ) and f4096).
“f2” indicates that this clock is f1(
φ) divided by 2. For operation of the
watchdog timer, refer to section on the watchdog timer.
When the STP instruction is executed,
φ, φBIU, and φCPU stop at the
“L” state.
The STP mode is terminated by acceptance of an interrupt, and the
oscillation is started. Simultaneously, supply of
φ is started.
When the watchdog timer starts to count down with Wf32 and the
most significant bit of the watchdog timer is cleared to “0”, supply of
φBIU and φCPU is restarted. The count source of the watchdog timer
is back to the count source which was selected before execution of
the STP instruction, and the generated interrupt request is accepted.
When the WIT instruction is executed,
φBIU and φCPU stops at the “L”
state. However,
φ is not stopped. Immediately after the interrupt re-
quest is accepted,
φBIU and φCPU start their operations.
In order to terminate the STP or WIT mode by a non-maskable inter-
rupt, it is necessary to make the interrupt request acceptable before
execution of the STP or WIT instruction. For setting method, refer to
the section on interrupts.
Figure 109 shows a circuit example with an external ceramic reson-
ator or a quartz crystal oscillator. The constants such as capacitance
etc. depend on a resonator. Therefore, for these constants, adopt the
oscillator/resonator manufacturer’s recommended values. Figure
110 shows a circuit e example with an external clock source.
Fig. 109 Circuit example with external ceramic resonator or quartz crystal oscillator
Fig. 110 Circuit example with external clock source
XIN
Rf
XOUT
Rd
CIN
COUT
XIN
XOUT
Left open.
External oscillation circuit
Vcc
Vss
相關PDF資料 |
PDF描述 |
|---|---|
| M38039MFL-XXXWG | 8-BIT, MROM, 16.8 MHz, MICROCONTROLLER, PBGA64 |
| M38039FFLSP | 8-BIT, FLASH, 16.8 MHz, MICROCONTROLLER, PDIP64 |
| M38039FFLKP | 8-BIT, FLASH, 16.8 MHz, MICROCONTROLLER, PQFP64 |
| M38049FFLWG | 8-BIT, FLASH, 16.8 MHz, MICROCONTROLLER, PBGA64 |
| M38102M5-XXXSP | 8-BIT, MROM, 4.19 MHz, MICROCONTROLLER, PDIP64 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| M37920FCCHP | 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER FLASH MEMORY VERSION |
| M37920FGCGP | 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER FLASH MEMORY VERSION |
| M37920FGCHP | 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER FLASH MEMORY VERSION |
| M37920S4CGP | 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:16 BIT CMOS MICROCOMPUTER |
| M37P75C4P3 | 功能描述:汽車連接器 Pin Contact RoHS:否 制造商:Amphenol SINE Systems 產品:Contacts 系列:ATP 位置數量: 型式:Female 安裝風格: 端接類型: 觸點電鍍:Nickel |
發布緊急采購，3分鐘左右您將得到回復。