參數資料
型號: GT-48001A
廠商: Galileo Technology Services, LLC
英文描述: Switched Ethernet Controller For 10BaseX(10BaseX交換式快速以太網控制器)
中文描述: 交換式以太網控制器10BaseX(10BaseX交換式快速以太網控制器)
文件頁數: 42/101頁
文件大小: 1235K
代理商: GT-48001A
GT-48001A Switched Ethernet Controller
Revision 1.6
45
11.4
Plug-and-Play Considerations In PCI Systems
In plug-and-play systems, when the BIOS writes 0xFFFF.FFFF to the Internal/DRAM Base Address register during ini-
tialization, the GT-48001A will return 0xFFC0.0000 when read back indicating the GT-48001A is requesting 4 MBytes
of PCI address space. Designers who wish to use more than one GT-48001A in a plug and play environment must
relocate the multiple GT-48001As into the same 128MByte region (the GalNet Protocol Region.) An alternative solution
is to isolate the GT-48001A’s on a secondary PCI bus through a PCI-to-PCI bridge device with address remapping
capability.
11.5
Unused PCI Bus in Stand-Alone Systems
Single-chip stand-alone applications do not require use of the PCI bus. The PCI bus pins must be connected as shown
in Table 24 to insure proper operation when not using the PCI bus. All pull-up and pull-down resistors should have a
value of 4.7K
. Be sure to have your own reset and 33.0 MHz clock on-board. All other PCI bus signals can remain
unconnected.
11.6
PCI Bus Arbiter in Multiple GalNet Device Systems
All GalNet systems that use more than one device will require a PCI bus arbiter. The arbiter examines the bus request
signals from each device and determines which device is granted the bus. Galileo provides reference designs for PCI
bus arbiters (implemented in inexpensive PALs) on our website.
It is important to note that individual systems may have different arbiter design requirements. For example, if your sys-
tem has several GT-48001A devices and a single GT-48002A (100-Mbps switch) it may make sense to give higher pri-
ority to the higher-speed 100BaseX interfaces.
Table 24: Pin Strapping Requirements for Unused PCI Signals
Pi n Na m e
St ra ppi ng
DevSel*
Pulled up to Vcc
Stop*
Pulled up to Vcc
Par*
No Connect
PErr*
Pulled up to Vcc
Frame*
Pulled up to Vcc
IRdy*
Pulled up to Vcc
TRdy*
Pulled up to Vcc
Gnt*
Pulled down to GND
IdSel*
Pulled down to GND
SErr*
No Connect
Req*
No Connect
Int*
No Connect
AD[31:0]
No Connect
CBE[3:0]
No Connect
相關PDF資料
PDF描述
GT-48002A Switched Fast Ethernet Controller for 100BaseX(100BaseX交換式快速以太網控制器)
GT-48004A Four Port Switched Fast Ethernet Controller(四端口、交換式快速以太網控制器)
GT-48006A Low Cost Two Port 10/100Mbps Ethernet Bridge/Switch Controller(低成本、雙端口10/100Mbps以太網橋式/交換式控制器)
GT-48207 Advanced Switched Ethernet Controllers for 10+10/100 BaseX(高級交換式 10+10/100 BaseX以太網控制器)
GT-48208 Advanced Switched Ethernet Controllers for 10+10/100 BaseX(高級交換式 10+10/100 BaseX以太網控制器)
相關代理商/技術參數
參數描述
GT482 制造商:CORNELL DUBILIER ELECTRONICS 功能描述:Cap Ceramic 82pF 3000V SL 5% (12 X 6mm) Radial 9.5mm 85°C
GT48212-A6-PBB1C000 制造商:Marvell 功能描述:
GT48212-A6-PBB-C000 制造商:Marvell 功能描述:12 PORT E + 2 PORT FE SWITCH (MANAGED) - Trays
GT48300-A1-BBE1C083 制造商:Marvell 功能描述:Marvell GT48300-A1-BBE1C083
GT48300-A1-BBE-C000 制造商:Marvell 功能描述:Marvell GT48300-A1-BBE-C000