參數資料
型號: GT-48001A
廠商: Galileo Technology Services, LLC
英文描述: Switched Ethernet Controller For 10BaseX(10BaseX交換式快速以太網控制器)
中文描述: 交換式以太網控制器10BaseX(10BaseX交換式快速以太網控制器)
文件頁數: 65/101頁
文件大?。?/td> 1235K
代理商: GT-48001A
GT-48001A Switched Ethernet Controller
66
Revision 1.6
16.3.2 Transmit data in progress
This signal indicates the port is transmitting data.
16.3.3 Receive data in progress
This signal indicates port receive activity.
16.3.4 Collision active
This signal indicates the port collision event detected by the port.
16.3.5 Full/Half duplex
This signal indicates the port duplex: active - full duplex, inactive - half duplex.
16.3.6 Receive Buffer Full
In order for this LED to be active, Rx Buffer Threshold must be enabled (see Table 4). This signal indicates the port re-
ceive buffer status: active - the buffer exceeds it's programmed threshold, inactive otherwise.
16.3.7 Forwarding of unknown packets enabled
This signal indicates the port mode of forwarding unknown packets: active - forwarding unknown packets enabled, in-
active otherwise.
16.3.8 The port is configured as Sniffer
This signal indicates if the port mode is configured as a monitor port: active - port is a source sniffer, inactive otherwise.
16.3.9 Link Fail State
This signal indicates the port link status: active - link is down, inactive - link is up.
16.3.10 Partition State
This signal indicates the port partition status: active - port entered partition state, inactive otherwise.
16.4
LED Signals Timing Type
16.4.1 Static LED Signals
These signals are stable for relatively long time periods. The LED indication directly reflects their current value.
16.4.2 Dynamic Internal Signals:
These signals are typically active for short time periods. In order to be visible through the LED Indication Interfaces, the
GT-48001A includes a "monostable" function per each of these dynamic signals so they can be viewed on the LED in-
dication output for a period of about 200 ms.
16.4.3
Table of Internal Activities/Status Driven via the LED Interface
The following table defines a bit by bit description of the internal signals driven through the LED Indications Serial Inter-
face. The bit number (bit#) refers to the activation of LEDStb. LEDStb is active for bit# 1. RESERVED bits contents is
not defined (i.e. can be either HIGH or LOW).
相關PDF資料
PDF描述
GT-48002A Switched Fast Ethernet Controller for 100BaseX(100BaseX交換式快速以太網控制器)
GT-48004A Four Port Switched Fast Ethernet Controller(四端口、交換式快速以太網控制器)
GT-48006A Low Cost Two Port 10/100Mbps Ethernet Bridge/Switch Controller(低成本、雙端口10/100Mbps以太網橋式/交換式控制器)
GT-48207 Advanced Switched Ethernet Controllers for 10+10/100 BaseX(高級交換式 10+10/100 BaseX以太網控制器)
GT-48208 Advanced Switched Ethernet Controllers for 10+10/100 BaseX(高級交換式 10+10/100 BaseX以太網控制器)
相關代理商/技術參數
參數描述
GT482 制造商:CORNELL DUBILIER ELECTRONICS 功能描述:Cap Ceramic 82pF 3000V SL 5% (12 X 6mm) Radial 9.5mm 85°C
GT48212-A6-PBB1C000 制造商:Marvell 功能描述:
GT48212-A6-PBB-C000 制造商:Marvell 功能描述:12 PORT E + 2 PORT FE SWITCH (MANAGED) - Trays
GT48300-A1-BBE1C083 制造商:Marvell 功能描述:Marvell GT48300-A1-BBE1C083
GT48300-A1-BBE-C000 制造商:Marvell 功能描述:Marvell GT48300-A1-BBE-C000