IEEE PCS REGISTERS (3.0 TO 3.25/3.0019’H) Note (1): This bit is not permitted to be a PCS loopback bit by IEEE 802.3ae-2002 subclause 45.2.3.1." />
參數資料
型號: BBT3821-JH
廠商: Intersil
文件頁數: 33/75頁
文件大?。?/td> 0K
描述: IC RE-TIMER OCTAL 192-BGA
標準包裝: 90
類型: 時鐘和數據恢復(CDR),多路復用器
PLL:
輸入: CML
輸出: CML,CMOS
電路數: 1
比率 - 輸入:輸出: 8:8
差分 - 輸入:輸出: 是/是
頻率 - 最大: 3.1875Gbps
電源電壓: 1.425 V ~ 2.5 V
工作溫度: 0°C ~ 70°C
安裝類型: 表面貼裝
封裝/外殼: 192-EBGA
供應商設備封裝: 192-EBGA-B(17x17)
包裝: 托盤
39
IEEE PCS REGISTERS (3.0 TO 3.25/3.0019’H)
Note (1): This bit is not permitted to be a PCS loopback bit by IEEE 802.3ae-2002 subclause 45.2.3.1.2 in 10GBASE-X PCS devices. Intersil has submitted a
maintenance request (#1113) to allow that use of this bit. Many XENPAK hosts, however, expect this loopback (which is mandatory for 10GBASE-R PCS
devices). Setting the 3.C001’h.7 bit, (Table 64) will activate this loopback enable bit, but cause the BBT3821 to be non-conforming to the current 802.3
Note (1): This bit is latched low on a detected Fault condition. It is set high on being read.
Note (1): Although the 802.3ae specification describes this register as type R/W, this register cannot have any value other than that reflecting the 10GBASE-X PCS.
Thus writing any other value is ignored, and the register is in effect type RO.
Table 57. IEEE PCS CONTROL 1 REGISTER
MDIO REGISTER ADDRESS = 3.0 (3.0000’h)
BIT(S)
NAME
SETTING
DEFAULT
R/W
DESCRIPTION
3.0.15
1.0.15
4.0.15
Reset
1 = reset
0 = reset done, normal
operation
0’b
R/W SC Writing 1 to this bit will reset the whole chip,
including the MDIO registers.
3.0.14(1)
PCS_LB_EN
Optionally, enable PCS
Loopback, otherwise
reserved
0’b
R/W
If enabled by EN_PCS_LB (see bit 3.C001’h.7,
Table 64) perform PCS Loopback, and is a R/W bit;
otherwise, effectively a reserved RO 0’b bit (1).
3.0.13
Speed Select
1 = 10Gbps
1’b
RO
1 = bits 5:2 select speed
3.0.12
Reserved
00’h
3.0.11
LOPOWER
0 = Normal Power
0’b
R/W
No Low Power Mode, writes ignored
3.0.10:7
Reserved
3.0.6
Speed Select
1 = 10Gbps
1’b
RO
1 = bits 5:2 select speed
3.0.5:2
Speed Select
0000 = 10Gbps
0’h
RO
Operates at 10Gbps
3.0.1:0
Reserved
0’b
Table 58. IEEE PCS STATUS 1 REGISTER
MDIO REGISTER ADDRESS = 3.1 (3.0001’h)
BIT
NAME
SETTING
DEFAULT
R/W
DESCRIPTION
3.1.15:8
Reserved
00’h
3.1.7
Local Fault
1 = PCS Local Fault
0
RO
Derived from Register 3.0008’h
3.1.6:3
Reserved
0’h
3.1.2
Rx Link Up
1 = PCS Rx Link Up
0 = PCS Rx Link Down
1 (1)
RO LL(1)
‘Up’ means CX4/LX4 signal level is OK, Byte
Synch and Lane-Lane Alignment have all
occurred
3.1.1
LoPwrAble
Low Power Ability
0
RO
Device does not support a low power mode
3.1.0
Reserved
0
Table 59. IEEE PCS TYPE SELECT REGISTER
MDIO REGISTER ADDRESS = 3.7 (3.0007’h)
BIT
NAME
SETTING
DEFAULT
R/W
DESCRIPTION
3.7.15:2
Reserved
000’h
3.7.1:0
PCS Type
01 = 10GBASE-X
01b
RO(1)
Writes ignored
BBT3821
相關PDF資料
PDF描述
VE-2NP-IW-B1 CONVERTER MOD DC/DC 13.8V 100W
MS27484E12A35P CONN PLUG 22POS STRAIGHT W/PINS
MAX491CSD IC TRANS RS485/RS422 14-SOIC
VE-2NN-IW-B1 CONVERTER MOD DC/DC 18.5V 100W
IDTQS34X245Q3G IC BUS SWITCH 32BIT CMOS 80QVSOP
相關代理商/技術參數
參數描述
BBT3821LP-JH 功能描述:IC RE-TIMER OCTAL 192-BGA RoHS:否 類別:集成電路 (IC) >> 時鐘/計時 - 專用 系列:- 標準包裝:1,500 系列:- 類型:時鐘緩沖器/驅動器 PLL:是 主要目的:- 輸入:- 輸出:- 電路數:- 比率 - 輸入:輸出:- 差分 - 輸入:輸出:- 頻率 - 最大:- 電源電壓:3.3V 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SSOP(0.209",5.30mm 寬) 供應商設備封裝:28-SSOP 包裝:帶卷 (TR) 其它名稱:93786AFT
BBTEKIT 功能描述:剝線和切削工具 COMPR AND STRIP TOOL KIT FOR RG59 RG6 CBL RoHS:否 制造商:Molex 產品:Cable Strippers 類型: 描述/功能:Stripper
BB-TERM3 功能描述:固定接線端子 3-Position Terminal Block Breakout RoHS:否 制造商:Phoenix Contact 產品:Fixed Terminal Blocks 類型:Wire to Board 節(jié)距:5.08 mm 位置/觸點數量:2 線規(guī)量程:26-16 電流額定值:13.5 A 電壓額定值:250 V 安裝風格:Through Hole 安裝角:Straight 端接類型:Screw 觸點電鍍:
BB-TG.30.8113 功能描述:ANT LTE, TERMINAL 制造商:b&b smartworx, inc. 系列:- 零件狀態(tài):在售 配件類型:天線 配套使用產品/相關產品:- 標準包裝:1
BBU-03 制造商:Highpoint Technology 功能描述:BATTERY BACK UP - Bulk