- 您現在的位置：買賣IC網 > PDF目錄371179 > T8102A H.100/H.110 Interface and Time-Slot Interchangers PDF資料下載
參數資料
| 型號： | T8102A |
| 英文描述： | H.100/H.110 Interface and Time-Slot Interchangers |
| 中文描述： | H.100/H.110接口和時隙Interchangers |
| 文件頁數： | 34/112頁 |
| 文件大?。?/td> | 1408K |
| 代理商： | T8102A |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁當前第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁
30
Lucent Technologies Inc.
Advance Data Sheet
November 1999
H.100/H.110 Interfaces and Time-Slot Interchangers
Ambassador T8100A, T8102, and T8105
2 Architecture and Functional
Description
(continued)
2.3 H-Bus Section
2.3.1 Memory Architecture
To access the H-bus, the devices use a new twist
on an existing approach to accessing large address
spaces: the data is stored in an independent double-
buffered SRAM which acts like the local data memory,
but the connection information for the H-bus is held in
three 512 location CAMs (T8102, T8105 only). Two
CAMs are used for two groups of 16 H-bus streams
each, and one CAM for all 16 local input/output pairs.
Each CAM compares 16 streams for read and write
and allows access time to the host microprocessor for
updates to the connections. Thus, each stream is
allotted three operations per 976 ns time slot, so there
are a maximum of 48 accesses per CAM per time
slot. The CAMs must operate at a rate of at least
20.34 ns/access*. The selected technology operates at
13 ns/access maximum, so an internal clock speed of
15.26 ns (65.536 MHz) is used.
For the following discussions, the reader should refer to
Figure 9. The combined comparison plus retrieval
operations take two CAM cycles, leaving little time for
microprocessor updates. To circumvent this, a separate
SRAM (actually, a register file) is tied to each CAM.
Each entry of this register file is associated with an
entry in the CAM on a location-by-location basis. (For
example, physical address 0xA7 in the CAM is coupled
with physical address 0xA7 of the register file.) The
CAMs will have only the comparand field for stream
and time-slot addresses, and the associated register
files will hold the data field, which is comprised of a tag
(an indirect pointer to the double-buffered data SRAM)
and some control bits. Using the associated SRAM
allows the operations to be pipelined so that the data
retrieval occurs while the CAMs are doing the next
comparison. The SRAM is double-buffered to permit
constant delay or minimum delay on a connection-by-
connection basis, as described in Section 2.2.1 Con-
stant Frame Delay and Minimum Delay Connections,
and as illustrated in Figure 5.
* The H-bus presents a unique set of problems. A full nonblocking,
double-buffered switch of 5120 locations has significant barriers in
size and in control of memory access time. Further, the traffic
between the local bus and H-bus is generally limited to a small
number of time slots at any given moment (120 full duplex is typical,
although we are permitting 256 duplex or 512 (T8102, T8105 only)
simplex connections), but the requirement to access any time slot
out of the full range of 5120 locations remains. To solve this, content
addressable memories (CAM) are utilized. They provide access to
the full 5120 locations through an encoded width (13 bits), but
require a depth equal to the maximum number of connections
required (512 [T8102, T8105 only]).
相關PDF資料 |
PDF描述 |
|---|---|
| T8105A | H.100/H.110 Interface and Time-Slot Interchangers |
| T8100 | H.100/H.110 Interface and Time-Slot Interchanger |
| T8110 | Version History |
| T8301 | T8301 Internet Protocol Telephone Phone-On-A-Chip⑩ IP Solution DSP |
| T8302 | T8302 Internet Protocol Telephone Advanced RISC Machine (ARM) Ethernet QoS Using IEEE 802.1q |
相關代理商/技術參數 |
參數描述 |
|---|---|
| T810-400B | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:HIGH PERFORMANCE TRIACS |
| T8105A | 制造商:AGERE 制造商全稱:AGERE 功能描述:H.100/H.110 Interface and Time-Slot Interchangers |
| T810-600B | 功能描述:雙向可控硅 8A TRIACS RoHS:否 制造商:STMicroelectronics 開啟狀態 RMS 電流 (It RMS):16 A 不重復通態電流:120 A 額定重復關閉狀態電壓 VDRM:600 V 關閉狀態漏泄電流（在 VDRM IDRM 下）:5 uA 開啟狀態電壓: 保持電流（Ih 最大值）:45 mA 柵觸發電壓 (Vgt):1.3 V 柵觸發電流 (Igt):1.75 mA 最大工作溫度: 安裝風格:Through Hole 封裝 / 箱體:TO-220AB |
| T810-600B | 制造商:STMicroelectronics 功能描述:TRIAC 8A 600V D-PAK |
| T810-600B-TR | 功能描述:雙向可控硅 8A TRIACS RoHS:否 制造商:STMicroelectronics 開啟狀態 RMS 電流 (It RMS):16 A 不重復通態電流:120 A 額定重復關閉狀態電壓 VDRM:600 V 關閉狀態漏泄電流（在 VDRM IDRM 下）:5 uA 開啟狀態電壓: 保持電流（Ih 最大值）:45 mA 柵觸發電壓 (Vgt):1.3 V 柵觸發電流 (Igt):1.75 mA 最大工作溫度: 安裝風格:Through Hole 封裝 / 箱體:TO-220AB |
發布緊急采購，3分鐘左右您將得到回復。