- 您現在的位置：買賣IC網 > PDF目錄371369 > 21440 (Intel Corp.) Multiport 10/100Mb/s Ethernet Controller(多端口10/100Mb/s 以太網控制器) PDF資料下載
參數資料
| 型號： | 21440 |
| 廠商： | Intel Corp. |
| 英文描述： | Multiport 10/100Mb/s Ethernet Controller(多端口10/100Mb/s 以太網控制器) |
| 中文描述： | 多端口10/100Mb/s以太網控制器（多端口支持10/100Mbps以太網控制器） |
| 文件頁數： | 65/92頁 |
| 文件大?。?/td> | 1352K |
| 代理商： | 21440 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁當前第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁
Network Interface Operation
6-8
21440 Multiport 10/100Mb/s Ethernet Controller
6.5.5
Flow Control
In the full-duplex mode, the 21440 identifies standard flow control frames during reception. If a
flow control frame is received and flow control mode is enabled (TX_PARAM<FLCE>), frame
transmission will be stopped until expiration of the pause time. If flow control frames are received
during frame transmission, the frame will be completely transmitted on the line, and then
transmission will stop. The 21440 identifies flow control frames according to the field matching
described in
Table 6-3
, and correctness of the CRC.
The value of fields 17
–
18 in the frame indicates the transmit pause time, represented in units of
slot times.
Flow control frames are not loaded into the receive FIFO. They are discarded following
identification, unless the 21440 is programmed to pass them (RX_FILT_ MOD<PFLC>).
6.6
MAC Full-Duplex Operation
In full-duplex mode (SER_MOD<FDX>), the 21440 activates the transmit and receive processes
simultaneously. It also supports receive back-to-back packets with a minimal interpacket gap
(IPG), in parallel with the transmission of back-to-back packets with an IPG of 96 bit times. In this
mode, the MAC will ignore both the carrier sense (crs{i}) and the collision detect (col{i}) signals.
6.7
MAC Loopback Operations
The 21440 supports two loopback modes:
Internal loopback
External loopback
6.7.1
Internal Loopback Mode
The internal loopback mode enables verification that the internal logic operates correctly. In this
mode, frames loaded in the transmit FIFO are transferred to the receive FIFO through the transmit
logic and receive logic. In the internal loopback mode, the 21440 disconnects from the network.
Frames are not transmitted onto the line (except in SYM mode), and frames received from the line
are rejected.
Table 6-3. Flow control Field Matching
Byte
Number
Value
Destination Address
1
–
6
01-80-C2-00-00-01
Type
13
–
14
88-08
Op-Code
15
–
16
00-01
相關PDF資料 |
PDF描述 |
|---|---|
| 21446 | Net186-EVAL-KT? 24.9KB (PDF) |
| 2145 | MONITORKABEL SUN BUCHSE SVGA STECKER |
| 2148C | MONITORKABEL SUN STECKER SVGA BUCHSE |
| 2148D | MONITORKABEL SUN STECKER SVGA STECKER |
| 2148 | MONITORKABEL SUN VGA ADAPTER |
相關代理商/技術參數 |
參數描述 |
|---|---|
| 2-1440000-2 | 制造商:TE Connectivity 功能描述:relay, OMR-C-105H,V000 |
| 2-1440000-3 | 功能描述:低信號繼電器 - PCB OMR-C-105H V300 RoHS:否 制造商:NEC 觸點形式:2 Form C (DPDT-BM) 觸點電流額定值: 線圈電壓:5 V 最大開關電流:1 A 線圈電流:1 A 線圈類型:Non-Latching 功耗:140 mW 端接類型:SMT 絕緣: 介入損耗: |
| 2-1440000-5 | 功能描述:低信號繼電器 - PCB OMR-C-109H V530 RoHS:否 制造商:NEC 觸點形式:2 Form C (DPDT-BM) 觸點電流額定值: 線圈電壓:5 V 最大開關電流:1 A 線圈電流:1 A 線圈類型:Non-Latching 功耗:140 mW 端接類型:SMT 絕緣: 介入損耗: |
| 2-1440000-6 | 制造商:TE Connectivity 功能描述:Electromechanical Relay SPST-NO 0.5A 12VDC 1.05KOhm Through Hole 制造商:TE Connectivity 功能描述:EM RLY SPST-NO 0.5A 12VDC 1.05KOHM TH - Bulk 制造商:TE Connectivity 功能描述:RELAY REED SPST 500MA 12V |
| 2-1440001-1 | 功能描述:通用繼電器 OMI-SH-206L 594 RoHS:否 制造商:Omron Electronics 觸點形式:1 Form A (SPST-NO) 觸點電流額定值:150 A 線圈電壓:24 VDC 線圈電阻:144 Ohms 線圈電流:167 mA 切換電壓:400 V 安裝風格:Chassis 觸點材料: |
發布緊急采購，3分鐘左右您將得到回復。