- 您現在的位置：買賣IC網 > PDF目錄224792 > PPXY8300A6T1 (FREESCALE SEMICONDUCTOR INC) DIFFERENTIAL, PEIZORESISTIVE PRESSURE SENSOR, RECTANGULAR, SURFACE MOUNT PDF資料下載
參數資料
| 型號： | PPXY8300A6T1 |
| 廠商： | FREESCALE SEMICONDUCTOR INC |
| 元件分類： | Pressure Sensor |
| 英文描述： | DIFFERENTIAL, PEIZORESISTIVE PRESSURE SENSOR, RECTANGULAR, SURFACE MOUNT |
| 封裝： | SOIC-20 |
| 文件頁數： | 149/162頁 |
| 文件大小： | 4316K |
| 代理商： | PPXY8300A6T1 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁當前第149頁第150頁第151頁第152頁第153頁第154頁第155頁第156頁第157頁第158頁第159頁第160頁第161頁第162頁
MPXY8300 Series
Sensors
Freescale Semiconductor
87
SECTION 12 LF RECEIVER
This module provides an interface between magnetic field communication transmissions (typically at 125 kHz) and the MCU. Two
pins are connected to a receiver coil located on the printed circuit board. When a magnetic field is present, low level voltages are
applied to the input pins. The module amplifies the signal and determines whether the proper carrier frequency is present. If valid
information is detected, the module will provide an interrupt request to the CPU. If no signal is detected or the information is
invalid, the module will return to a very low power state and periodically wake-up and sample the input.
The module may be placed in three modes:
Carrier detect mode — This mode determines whether the received signal is above a certain amplitude, is present for a
minimum duration, and has a carrier frequency between a minimum and maximum level. If the three criteria are met, the
CPU receives an interrupt request.
Manchester data mode — This mode is for receiving Manchester coded information. The information being transmitted will
be modulated using on/off keying and will have a carrier frequency of approximately 125 kHz. The module will use automatic
gain control to acquire and track the incoming signal, which may vary greatly due to changes in antenna distance and
orientation from the transmitter. The module will monitor: amplitude, carrier frequency, decoded bit timing, and message ID.
If all of the criteria are met, the CPU will be interrupted when each byte of information is available.
Direct access mode — This mode is provided primarily for system development when the antenna characteristics are being
analyzed. In this mode, the CPU is directly provided the demodulated data stream. As in Manchester data mode, automatic
gain control will be used to acquire and track the input waveform.
The module provides a programmable periodic wake-up mechanism for carrier and Manchester data modes. This allows the
module to be normally in a very low power state and to periodically wake-up to sample for incoming information. In direct access
mode, the module will stay active. The block diagram of the module is shown in Figure 12-1. The module is divided into two sub-
blocks:
Detector — Analog and digital sub-block that performs:
Signal amplification
On/off keying demodulation
Carrier frequency digital bandpass filter
Automatic gain control
Decoder — Digital logic that performs:
Interface to the CPU bus
Manchester bit timing decoding
Wake-Up timing
12.1
External Signal Description
12.1.1
Modulated Signal input
Two port pins act as inputs to the LFR detector.
12.1.2
Clock inputs
A medium frequency oscillator (MFO) of approximately 125 kHz will be provided to the module to clock the logic of the decoder.
A frequency doubled version of the MFO is supplied to the detector. The MFO will have an enable signal from the LFR module.
A low frequency oscillator (LFO) of approximately 1 kHz will be provided to the module at all times in all MCU modes of operation.
相關PDF資料 |
PDF描述 |
|---|---|
| PR35MT2 | RECTANGULAR ADAPTER |
| PR406-BCR5HD | T-1 3/4 SINGLE COLOR LED, RED, 4.6 mm |
| PR44-PCG28H-CG | SINGLE COLOR LED, GREEN, 6.35 mm |
| PRADA1-07F-BR000 | ROCKER SWITCH, DPST, LATCHED, 7A, PANEL MOUNT |
| PRADD1-07F-BB000 | ROCKER SWITCH, DPST, LATCHED, 7A, PANEL MOUNT |
相關代理商/技術參數 |
參數描述 |
|---|---|
| PPYY12C0.75 | 制造商:Farnell / Pro-Power 功能描述:CABLE YY 12 CORE 0.75MM PER M 制造商:pro-power 功能描述:CABLE, YY, 12 CORE, 0.75MM, PER M 制造商:PRIVATE LABEL 功能描述:CABLE, YY, 12 CORE, 0.75MM, PER M, No. of Conductors:12, Voltage Rating:500V, No 制造商:pro-power 功能描述:CABLE, YY, 12 CORE, 0.75MM, PER M, No. of Conductors:12, Voltage Rating:500V, No. of Max Strands x Strand Size:-, Conductor Area CSA:0.75mm2, Jacket Colour:Grey, Jacket Material:PVC (Polyvinyl Chloride), External Diameter:9.9mm, |
| PPYY12C0.75 100M | 制造商:Farnell / Pro-Power 功能描述:CABLE YY 12 CORE 0.75MM 100M 制造商:PRIVATE LABEL 功能描述:CABLE, YY, 12 CORE, 0.75MM, 100M, Reel Length (Imperial):328ft, Reel Length (Met 制造商:pro-power 功能描述:CABLE, YY, 12 CORE, 0.75MM, 100M, Reel Length (Imperial):328ft, Reel Length (Metric):100m, No. of Conductors:12, Voltage Rating:500V, No. of Max Strands x Strand Size:-, Conductor Area CSA:0.75mm2, Jacket Colour:Grey, Jacket , RoHS Compliant: Yes |
| PPYY12C0.75 50M | 制造商:Farnell / Pro-Power 功能描述:CABLE YY 12 CORE 0.75MM 50M 制造商:pro-power 功能描述:CABLE, YY, 12 CORE, 0.75MM, 50M |
| PPYY12C1.50 | 制造商:Farnell / Pro-Power 功能描述:CABLE YY 12 CORE 1.5MM PER M 制造商:pro-power 功能描述:CABLE, YY, 12 CORE, 1.5MM, PER M |
| PPYY12C1.50 50M | 制造商:Farnell / Pro-Power 功能描述:CABLE YY 12 CORE 1.5MM 50M 制造商:pro-power 功能描述:CABLE, YY, 12 CORE, 1.5MM, 50M |
發布緊急采購，3分鐘左右您將得到回復。