- 您現在的位置：買賣IC網 > PDF目錄224792 > PPXY8300A6T1 (FREESCALE SEMICONDUCTOR INC) DIFFERENTIAL, PEIZORESISTIVE PRESSURE SENSOR, RECTANGULAR, SURFACE MOUNT PDF資料下載
參數資料
| 型號： | PPXY8300A6T1 |
| 廠商： | FREESCALE SEMICONDUCTOR INC |
| 元件分類： | Pressure Sensor |
| 英文描述： | DIFFERENTIAL, PEIZORESISTIVE PRESSURE SENSOR, RECTANGULAR, SURFACE MOUNT |
| 封裝： | SOIC-20 |
| 文件頁數： | 29/162頁 |
| 文件大?。?/td> | 4316K |
| 代理商： | PPXY8300A6T1 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁當前第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁第154頁第155頁第156頁第157頁第158頁第159頁第160頁第161頁第162頁
MPXY8300 Series
Sensors
124
Freescale Semiconductor
14.3
Definition of Signal Ranges
Each measured parameter (pressure, voltage, temperature, acceleration) results from an ADC conversion of an analog signal.
This ADC result may then be passed by the firmware to the application software as either the raw ADC result or further
compensated and scaled for an output between one and the maximum digital value minus one. The minimum digital value of zero
and the maximum digital value are reserved as error codes.
The signal ranges and their significant data points are shown in Figure 14-1. In this definition the signal source would normally
output a signal between SINLO and SINHI. Due to process, temperature and voltage variations this signal may increase its range
to SINMIN to SINMAX. In all cases the signal will be between the supply rails, so that the ADC will convert it to a range of digital
numbers between 0 and 1023. These digital numbers will have corresponding DINMIN, DINLO, DINHI, DINMAX values. The ADC
digital value is taken by the firmware and compensated and scaled to give the required output code range.
Digital input values below DINMIN and above DINMAX are immediately flagged as being out of range and generate error bits and
the output is forced to the 0 value.
Digital values below DINLO (but above DINMIN) or above DINHI (but not DINMAX) will most likely cause an output that would be less
than 1 or greater than 510, respectively. These cases are considered underflow or overflow, respectively. Underflow results will
be forced to a value of 1. Overflow results will be forced to a value of 510.
Digital values between DINLO and DINHI will normally produce an output between 1 to 510 (for a 9-bit result). In some isolated
cases due to compensation calculations and rounding the result may be less than 1 or greater than 510, in which case the
underflow and overflow rule mentioned above is used.
Table 14-3 Device ID Coding Descriptions
Field
Description
CODE0, 7:5
REV0:2
Revision number for the multiple-chip-module from 0 to 7.
CODE0, 7:5
PRG0:2
Calibrated range for pressure and acceleration. First code of $0 for 100-800 kPa, +/-10 x-axis acceler-
ometer and 0-60g z-axis accelerometer. Other codes to be assigned as produced.
CODE0, 1:0
SUPP0:1
Number of silicon device supplier from 0 to 3.
CODE1:4, 7:0
ID31:0
32-bit serial number for each device. All numbers to be unique, but numbering sequence to be deter-
mined by Freescale manufacturing process.
CODE5, 7:0
Reserved
Reserved for Freescale firmware description.
相關PDF資料 |
PDF描述 |
|---|---|
| PR35MT2 | RECTANGULAR ADAPTER |
| PR406-BCR5HD | T-1 3/4 SINGLE COLOR LED, RED, 4.6 mm |
| PR44-PCG28H-CG | SINGLE COLOR LED, GREEN, 6.35 mm |
| PRADA1-07F-BR000 | ROCKER SWITCH, DPST, LATCHED, 7A, PANEL MOUNT |
| PRADD1-07F-BB000 | ROCKER SWITCH, DPST, LATCHED, 7A, PANEL MOUNT |
相關代理商/技術參數 |
參數描述 |
|---|---|
| PPYY12C0.75 | 制造商:Farnell / Pro-Power 功能描述:CABLE YY 12 CORE 0.75MM PER M 制造商:pro-power 功能描述:CABLE, YY, 12 CORE, 0.75MM, PER M 制造商:PRIVATE LABEL 功能描述:CABLE, YY, 12 CORE, 0.75MM, PER M, No. of Conductors:12, Voltage Rating:500V, No 制造商:pro-power 功能描述:CABLE, YY, 12 CORE, 0.75MM, PER M, No. of Conductors:12, Voltage Rating:500V, No. of Max Strands x Strand Size:-, Conductor Area CSA:0.75mm2, Jacket Colour:Grey, Jacket Material:PVC (Polyvinyl Chloride), External Diameter:9.9mm, |
| PPYY12C0.75 100M | 制造商:Farnell / Pro-Power 功能描述:CABLE YY 12 CORE 0.75MM 100M 制造商:PRIVATE LABEL 功能描述:CABLE, YY, 12 CORE, 0.75MM, 100M, Reel Length (Imperial):328ft, Reel Length (Met 制造商:pro-power 功能描述:CABLE, YY, 12 CORE, 0.75MM, 100M, Reel Length (Imperial):328ft, Reel Length (Metric):100m, No. of Conductors:12, Voltage Rating:500V, No. of Max Strands x Strand Size:-, Conductor Area CSA:0.75mm2, Jacket Colour:Grey, Jacket , RoHS Compliant: Yes |
| PPYY12C0.75 50M | 制造商:Farnell / Pro-Power 功能描述:CABLE YY 12 CORE 0.75MM 50M 制造商:pro-power 功能描述:CABLE, YY, 12 CORE, 0.75MM, 50M |
| PPYY12C1.50 | 制造商:Farnell / Pro-Power 功能描述:CABLE YY 12 CORE 1.5MM PER M 制造商:pro-power 功能描述:CABLE, YY, 12 CORE, 1.5MM, PER M |
| PPYY12C1.50 50M | 制造商:Farnell / Pro-Power 功能描述:CABLE YY 12 CORE 1.5MM 50M 制造商:pro-power 功能描述:CABLE, YY, 12 CORE, 1.5MM, 50M |
發布緊急采購，3分鐘左右您將得到回復。