參數資料
型號： DSP16210
英文描述： TVS 400W 6.5V UNIDIRECT SMA
中文描述： DSP16210數字信號處理器
文件頁數： 31/173頁
文件大?。?/td> 2621K
代理商： DSP16210
Data Sheet
July 2000
DSP16210 Digital Signal Processor
Lucent Technologies Inc.
DRAFT COPY
31
Hardware Architecture
(continued)
External Memory Interface (EMI)
(continued)
Functional Timing
(continued)
Table 9
describes the computation of wait-states for read and write accesses (R
X
, R
Y
, and W) for each segment of
EMI storage, including the IORAM memories and ESIO memory-mapped registers.
Table 9. Wait-States
Access
X-memory read
Y-memory read
Write wait-states can be transparent to the core if the instruction that writes EMI storage is followed by non-EMI
instructions. If write wait-states are transparent, then the core continues execution while the EMI completes the
write operation. For example, the single write external wait-state in the following code segment is transparent and
does not stall the core execution:
*r0++=a0h
a0h=a0h+1
/* r0 points to IORAM, single-word write, one wait-state
/* 1-cycle instruction, no EMI access -- wait-state is transparent
*/
*/
READY Pin
The READY input pin permits an external device to extend the length of an EMI access cycle. The READY pin can
be used if the number of access cycles programmable in the
mwait
register (
Table 58 on page 101
) is insufficient,
or if the desired number of access cycles varies from access to access. To use the READY pin for a memory seg-
ment access, the access time field in the
mwait
register (IATIM[3:0], YATIM[3:0], or XATIM[3:0]) must be pro-
grammed to a value of four or greater and the corresponding RDYEN[2:0] field of
mwait
must be set. If the access
time field in
mwait
for the memory segment is less than four or if the RDYEN[2:0] field of
mwait
for the memory
segment is cleared, then the DSP16210 ignores the READY pin when accessing that segment. On device reset,
the RDYEN[2:0] fields are cleared, causing the DSP16210 to ignore the READY pin by default.
Figure 39 on
page 152
illustrates the operation of the READY pin.
The DSP16210 internally synchronizes the READY pin to the internal clock (CLK). READY must be asserted at
least five cycles (plus a setup time
1
) prior to the end of the external memory operation. The DSP16210 adds the
number of cycles that READY is asserted to the access time.
Segment
EROM
Number of Wait-States
(size
×
(XATIM[3:0] + 1) + misaligned)
(size
×
(YATIM[3:0] + 1) + misaligned)
(size
×
(IATIM[3:0] + 1) + misaligned)
(size
×
2 + misaligned)
(size
×
(YATIM[3:0] + 1) + misaligned)
(size
×
(IATIM[3:0] + 1) + misaligned)
(size + misaligned)
sizeis one for a 16-bit access and two for a 32-bit access. misalignedis one for a misaligned double-word access and zero for a single-word
access or an aligned double-word access.
Write wait-states can be transparent to the core if the EMI write instruction is followed by non-EMI instructions.
R
X
R
Y
ERAMHI or ERAMLO
IO
IORAM or ESIO
ERAMHI or ERAMLO
IO
IORAM or ESIO
Y-memory write
W
1. The READY pin setup time is t140 in
Table 108 on page 152
.
相關PDF資料
PDF描述
DSP1627 TVS 400W 6.5V BIDIRECT SMA
DSP1629 TVS 400W 64V UNIDIRECT SMA
DSP16410C TVS 400W 7.0V UNIDIRECT SMA
DSP16410 16-bit fixed point DSP with Flash
DSP25-16AR Phase-leg Rectifier Diode
相關代理商/技術參數
參數描述
DSP1627 制造商:AGERE 制造商全稱:AGERE 功能描述:DSP1627 Digital Signal Processor
DSP1627F32K10IR 制造商:未知廠家 制造商全稱:未知廠家 功能描述:DSP|16-BIT|CMOS|QFP|100PIN|PLASTIC
DSP1627F32K10IT 制造商:未知廠家 制造商全稱:未知廠家 功能描述:DSP|16-BIT|CMOS|QFP|100PIN|PLASTIC
DSP1627F32K11I 制造商:未知廠家 制造商全稱:未知廠家 功能描述:16-Bit Digital Signal Processor
DSP1627F32K11IR 制造商:未知廠家 制造商全稱:未知廠家 功能描述:DSP|16-BIT|CMOS|QFP|100PIN|PLASTIC
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*