- 您現在的位置：買賣IC網 > PDF目錄371179 > T7630 T7630 Dual T1/E1 5.0 V Short-Haul Terminator (Terminator-II) PDF資料下載
參數資料
| 型號： | T7630 |
| 英文描述： | T7630 Dual T1/E1 5.0 V Short-Haul Terminator (Terminator-II) |
| 中文描述： | T7630雙T1/E1的5.0V的短途終結者（終結者-Ⅱ） |
| 文件頁數： | 113/210頁 |
| 文件大?。?/td> | 3075K |
| 代理商： | T7630 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁當前第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁第154頁第155頁第156頁第157頁第158頁第159頁第160頁第161頁第162頁第163頁第164頁第165頁第166頁第167頁第168頁第169頁第170頁第171頁第172頁第173頁第174頁第175頁第176頁第177頁第178頁第179頁第180頁第181頁第182頁第183頁第184頁第185頁第186頁第187頁第188頁第189頁第190頁第191頁第192頁第193頁第194頁第195頁第196頁第197頁第198頁第199頁第200頁第201頁第202頁第203頁第204頁第205頁第206頁第207頁第208頁第209頁第210頁
Lucent Technologies Inc.
Lucent Technologies Inc.
113
Preliminary Data Sheet
October 2000
T7630 Dual T1/E1 5.0 V Short-Haul Terminator (Terminator-II)
Concentration Highway Interface
(continued)
Rate adaptation is required for all DS1 formats between the 1.544 Mbits/s line rate and 2.048 Mbits/s,
4.966 Mbits/s, or 8.182 Mbits/s CHI rate. This is achieved by means of stuffing eight idle time slots into the existing
twenty-four time slots of the T1 frame. Idle time slots can occur every fourth time slot (starting in the first, second,
third, or fourth time slot) or be grouped together at the end of the CHI frame as described in register FRM_PR43
bit 0—bit 2. The positioning of the idle time slots is the same for transmit and receive directions. Idle time slots con-
tain the programmable code of register FRM_PR23. Unused time slots can be disabled by forcing the TCHIDATA
interface to a high-impedance state for the interval of the disabled time slots.
CHI Parameters
The CHI parameters that define the receive and transmit paths are given in Table 57.
Table 57. Summary of the T7630’s Concentration Highway Interface Parameters
Name
HWYEN
Description
Highway Enable (FRM_PR45 bit 7).
A 1 in this bit enables the transmit and receive
concentration highway interfaces. This allows the framer to be fully configured before
transmission to the highway. A 0 forces the idle code as defined in register
FRM_PR22, to be transmitted to the line in all payload time slots while TCHIDATA is
forced to a high-impedance state for all CHI transmitted time slots.
Concentration Highway Master Mode (PRM_PR45 bit 4).
The default mode
CHIMM = 0 enables an external system frame synchronization signal (TCHIFS) to
drive the transmit CHI. A 1 enables the transmit CHI to generate a system frame syn-
chronization signal from the receive line clock. The transmit CHI system frame syn-
chronization signal is generated on the TCHIFS output pin. Applications using the
receive line clock as the reference clock signal of the system are recommended to
enable this mode and use the TCHIFS signal generated by the framer. The receive
CHI path is
not
affected by this mode.
CHI Double Time-Slot Mode (FRM_PR65 bit 1 and FRM_PR66 bit 1).
CHIDTS
defines the 4.096 Mbits/s and 8.192 Mbits/s CHI modes. CHIDTS = 0 enables the 32
contiguous time-slot mode. This is the default mode. CHIDTS = 1 enables the double
time-slot mode in which the transmit CHI drives TCHIDATA for one time slot and then
3-states for the subsequent time slot, and the receive CHI latches data from RCHI-
DATA for one time slot and then ignores the following time slot and so on. CHIDTS = 1
allows two CHIs to interleave frames on a common bus.
Transmit Frame Edge (FRM_PR46 bit 3).
TFE = 0 (or 1), TCHIFS is sampled on the
falling (or rising) edge of TCHICK. In CHIMM (CHI master mode), the TCHIFS pin
outputs a transmit frame strobe to provide synchronization for TCHIDATA. When
TFE = 1 (or 0), TCHIFS is centered around rising (or falling) edge of TCHICK. In this
mode, TCHIFS can be used for receive data on RCHIDATA. The timing for TCHIFS in
CHIMM = 1 mode is identical to the timing for TCHIFS in CHIMM = 0 mode.
Receive Frame Edge (FRM_PR46 bit 7).
RFE = 0 (or 1), RCHIFS is sampled on the
falling (or rising) edge of RCHICK.
CHI Data Rate (FRM_PR45 bit 2 and bit 3).
Two-bit control for selecting the CHI
data rate. The default state (00) enables the 2.048 Mbits/s.
CDRS Bit:2 3CHI Data Rate
0 0 2.048 Mbits/s
0 1 4.096 Mbits/s
1 0 8.192 Mbits/s
1 1 Reserved
CHIMM
CHIDTS
TFE
RFE
CDRS0—CDRS1
相關PDF資料 |
PDF描述 |
|---|---|
| T7630 | Dual T1/E1 5.0 V Short-Haul Terminator (Terminator-II)(雙 T1/E1 5.0V短距離通信終端器) |
| T8100A | H.100/H.110 Interface and Time-Slot Interchangers |
| T8102A | H.100/H.110 Interface and Time-Slot Interchangers |
| T8105A | H.100/H.110 Interface and Time-Slot Interchangers |
| T8100 | H.100/H.110 Interface and Time-Slot Interchanger |
相關代理商/技術參數 |
參數描述 |
|---|---|
| T7630426 | 制造商:COOPER INDUSTRIES 功能描述:CC ACCESYS / #2450 3/8 Spring Snap Link Stainless Steel UPC Tagged |
| T-7630-TL2-DB | 制造商:Legerity 功能描述:5V DUAL T1/E1 SHORT-HAUL TERMINATOR |
| T7633 | 制造商:AGERE 制造商全稱:AGERE 功能描述:Dual T1/E1 3.3 V Short-Haul Terminator |
| T7645036 | 功能描述:手工工具 Campbell Snap Link #2450, 7/16", Steel RoHS:否 制造商:Molex 產品:Extraction Tools 類型: 描述/功能:Extraction tool |
| T7645106 | 制造商:COOPER INDUSTRIES 功能描述:CC ACCESYS / #7350 1/8 Quick Link Steel Zinc Plated UPC Tagged |
發布緊急采購，3分鐘左右您將得到回復。