
166
Agere Systems Inc.
Data Sheet
May 2001
and Packet Payload Engine
Ambassador T8110 PCI-Based H.100/H.110 Switch
15 Electrical Characteristics
15.1 Absolute Maximum Ratings
Stresses in excess of the absolute maximum ratings can cause permanent damage; the table below shows abso-
lute stress ratings only. Functional operation of the device is not implied at these or any other conditions in excess
of those given in the operational sections of this data sheet. Exposure to absolute maximum ratings for extended
periods can adversely affect device reliability.
15.1.1 Handling Precautions
Although protection circuitry has been designed into this device, proper precautions should be taken to avoid expo-
and a charged-device model (CDM) for ESD-susceptibility testing and protection design evaluation. ESD voltage
thresholds are dependent on the circuit parameters used to define the model. No industry-wide standard has been
adopted for CDM. However, a standard HBM (resistance = 1500 W, capacitance = 100 pF) is widely used and,
therefore, can be used for comparison purposes. The T8110 has a HBM ESD threshold voltage rating of 1500 V
minimum.
15.2 Crystal Specifications
15.2.1 XTAL1 Crystal
The T8110 requires a 16.384 MHz clock source derived from an oscillator or a crystal. If a crystal is used it has to
be a 16.384 MHz crystal and must be connected between the XTAL1_IN and the XTAL1_OUT pins. External 24 pF,
5% capacitors must be connected from XTAL1_IN and XTAL1_OUT to Vss, as shown in the diagram below.
The ±32 ppm tolerance is the suggested value if the oscillator is used as the clocking source while mastering the
bus. Otherwise, a crystal with a lesser tolerance can be used. The crystal specifications are shown below.
Table 118. Absolute Maximum Ratings
Parameter
Symbol
Min
Max
Unit
Supply Voltage
XTAL1_IN, XTAL2_IN, XTAL1_OUT, XTAL2_OUT pins
Voltage Applied to I/O Pins
Operating Temperature
Storage Temperature
V
DD
—
—
—
T
stg
—
V
SS
4.2
V
DD
V
DD
5.5
85
125
V
V
V
°C
°C
V
SS
– 0.3
–40
–55
Table 119. XTAL1 Specifications
Parameter
Value
Frequency
Oscillation Mode
Effective Series Resistance
Load Capacitance
Shunt Capacitance
Frequency Tolerance and Stability
16.384 MHz
Fundamental, parallel resonance
50
maximum
18 pF
7 pF maximum
32 ppm
5-6390f(c)
V
SS
24 pF
24 pF
1 M
16.384 MH
Z
CRYSTAL
T8110
XTAL1_IN
XTAL1_OUT